Ford 7600

Die beiden vorderen Halterungsarme des HV-Batteriegehäuses können brechen. Durch Kontakt des HV-Batteriegehäuses mit dem Kraftstofftank kann es zu einem Kraftstoffleck mit Brandgefahr kommen. Des Weiteren ist die Crashsicherheit der Batterie nicht mehr gewährleistet.

A screw and push nut may come into contact with the wiring harness behind the driver-side instrument panel and damage the wires. As a result, this could cause a loss of drive power, increasing the risk of an accident. Moreover, the wiring harness could overheat due to a short circuit, increasing the risk of fire. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

The side airbag may not deploy correctly, and the B-pillar panelling may become detached during deployment. In addition, the head airbag may not adequately protect occupants in certain front seating positions. These could reduce occupant protection in the event of a collision and increase the risk of injury. The product does not comply with the Regulation on the approval and market surveillance of motor vehicles and their trailers, and of systems, components and separate technical units intended for such vehicles.

Die Verkehrszeichenerkennung und das Geschwindigkeits- und Fahrerwarnsystem können deaktiviert werden, ohne dass dies angezeigt wird bzw. obwohl angezeigt wird, dass beide Systeme aktiv sind.

Had a Ford 7600 that broke a camshaft. The camshaft walked forward, breaking the retaining plate and the timing cover and sheared the camshaft and one of the retaining plate bolts off. Rebuilt the engine. When we fired it up it barely ran before locking up. Took the timing cover off and found that the camshaft retaining plate was broken and both bolts were sheared off. Any thoughts or advice? Is there a better subreddit to post this in?